B - Brake Pedal Area
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
BRAKE PEDAL AND COMPONENTS REMOVING AND INSTALLING PROCEDURE
| No. |
Designation |
Qty. |
Removal |
Installation |
| 7 |
Stop light switch |
1 |
Release by turning 90°, and pull out of the installation opening |
Adjust stop light switch if necessary; refer to ADJUSTING BRAKE PUSH ROD (ADJUSTING STOP LIGHT SWITCH)
. |
| 8 |
Return spring |
1 |
Disengage at body. Not present on vehicles before Mod. '98 |
If return spring has no sleeve (protective sheath), provide sleeve |
| 9 |
Threaded bushing |
1 |
|
Tighten to 10 Nm (7.5 ft.lb) |
| 10 |
Pin |
1 |
|
|
| 11 |
Lock nut |
1 |
|
Tighten to 20 Nm (15.0 ft.lb) (tighten to 30 Nm (22 ft.lb) on Boxster before Mod. '98) |
| 12 |
Hexagon nut M8 |
1 |
|
Replace; tighten to 10 Nm (7.5 ft.lb) |
| 13 |
Pedal bearing axle |
1 |
Unscrew at hexagon |
Grease in area of the bearing bushings 6X and 14X
, and tighten to 8...10 Nm (6.0...7.5 ft.lb) |
| 14 |
Brake pedal |
1 |
Pull out; to do this, turn the brake pedal and/or push rod accordingly if necessary |
|
| 14X |
Bushings |
2 |
Remain in the brake pedal |
Check, replace if necessary. Lubricate. Use grease specified |