A - Clutch Pedal Area
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
CLUTCH PEDAL AND COMPONENTS REMOVING AND INSTALLING PROCEDURE
| No. (1) | Designation | Qty. | Removal | Installation | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
| 1 | Switch | 1 | Release by turning 90°, and pull out of the installation opening | Before installation, pull operating plunger out of the switch as far as it will go | ||||||
| 2 | Retaining clip | 1 | Replace if necessary | |||||||
| 3 | Pin | 1 | ||||||||
| 4 | Clamp | 1 | Replace | |||||||
| 5 | Boost spring with bracket (bracket cannot be removed before Mod. '98) | 1 | Secure boost spring with cotter pin (No. 5) Insert the cotter pin (phi 3 mm) into the assembly bore and bend over ends. Then undo the three fastening nuts of the bracket and remove the boost spring together with bracket and clutch pedal lever (No. 6) |
Install the assembly consisting of bracket, boost spring and clutch pedal lever. Observe proper allocation when replacing the boost spring.(3) Observe assembly and adjustment specification for the bracket (assembly instructions under Installation, step 4) |
||||||
| 5a | Boost spring bearing | 2 | Replace if necessary. Always observe note with regard to greasing(3) | |||||||
| 5b | Pin | 1 | Always observe note with regard to greasing (3) | |||||||
| 6 | Clutch pedal lever | 1 | Remove together with boost spring No. 5 and bracket | |||||||
| 6X | Bushings | 2 | Remain in the clutch pedal lever | Check, replace if necessary. Lubricate. Use grease specified(2) | ||||||
|
||||||||||