Affixing the adhesive weights
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Remove the protective film only immediately prior to sticking on the weight, as prolonged exposure to the air will reduce the bonding strength!
- Pay attention to cleanliness!
- Determine exact position of the balancing weights (if necessary, provisionally stick on the balancing weights with a strip of adhesive tape until the correct position is determined).
- Prepare bonding surface on the rim. The bonding surface must be perfectly clean and free of grease.
- Remove protective paper from the bonding surface of the weight and press the weight firmly into place.
- The adhesive weight must be in contact uniformly over the entire surface.
- Check to ensure that the balancing weight is seated firmly. It must not be possible to detach the weight that was just stuck onto the rim by the application of a shear load at right angles to the longitudinal axis of the weight.