Notes on removal and installation: Removal

Remove brake disc and speed sensor.
Press out wheel hub with pressure piece P 297 A (tool A). Use the separator (tool B) for support. If there is not enough space for the wheel hub between the press, appropriate shims will additionally be necessary.

Fig 1: Pressing Out Wheel Hub Using Pressure Piece
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Remove retainer plate (lid / four screws) and brake disc cover.
Heat wheel bearing housing to approx. 100° C (max. 120° C). Press out wheel bearing with tubular piece VW 415 A (tool C).

Fig 2: Pressing Out Wheel Bearing Using Tubular Piece
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Press inner wheel bearing race off the wheel hub (see Fig 3 ). To do this, use pressure piece P 297 A (tool A) in combination with the separator (tool B).

Fig 3: Pressing Inner Wheel Bearing Race Off Wheel Hub
Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

First pull the inner bearing race several millimeters off the wheel hub (see Fig 4 ) so that the separator can be put into place. For this purpose, use a two-claw puller in combination with a suitable pressure piece (e.g. VW 433).

Fig 4: Pulling Inner Bearing Race Off Wheel Hub
Courtesy of PORSCHE OF NORTH AMERICA, INC.