New front-axle cross member - as of model '02
- As of model '02, the front-axle cross member is attached to the body at the rear fastening with two screws -arrows-
. See Fig 1
. Up to this (up to the end of model '01), only one screw was used in the fastening.
Courtesy of PORSCHE OF NORTH AMERICA, INC.
- The tightening torque has not been changed.
- The previous front-axle cross member -F1-
, with one fastening screw securing it to the body (per side) is still available as a spare part.
- Only certain combinations of front-axle cross member attachment -F1 or F2-
to the body is permitted!
- F2
- 2 fastening points (as of model '02)
- F1
- 1 fastening point