Installing cowl panel cover

Fig 1: Installing Cowl Panel Cover - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

COWL PANEL COVER INSTALLING PROCEDURE - TARGA

No.	Procedure	Instructions
		Before installing the covers, the flanges of the body must be cleaned.
		See Tools and materials .
		Cut adhesive tape to a width of 5 mm and stick onto the cowl panel cover.
		See Tools and materials .
1	Installing cowl panel cover	Pull protective film off the bonding area.
2	Screwing in fastening screws	Move cowl panel cover -1-Section A-A-B-C-1-2- . See Fig 1.
3	Installing roof joint strip	Position the roof joint strip onto the sheetmetal lugs at the front and rear and move 1 cm in -direction of arrow A- . See Fig 1.