Disassembling and assembling cover for the oddments tray
ODDMENTS TRAY COVER DISASSEMBLING AND ASSEMBLING PROCEDURE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Fastening screws | 8 | ||
| 2 | Cover, oddments tray | 1 | ||
| 3 | Fastening screws | 2 | ||
| 4 | Retaining bracket | 1 | Undo the fastening screws -3-Note:--7-4-8- . See Fig 1 . | Insert the retaining bracket -4-8-3- . See Fig 1 . |
| 5 | Hinge pin | 1 | Press the hinge pin -5-7-6- . See Fig 1 . | Position the spring -7-6-5- . See Fig 1 . |
| 6 | Lower section of oddments tray cover | 1 | ||
| 7 | Spring | 1 | ||
| 8 | Limiting band | 1 | Unclip the limiting band -8- . See Fig 1 . | Clip the retaining pin together with the limiting band -8- . See Fig 1 . |