Test and adjusting values
NOTE:
- Illustration of the gap dimensions
- Until model year 2001
- As of model year 2002
TEST AND ADJUSTING VALUES CHART
| Designation | Dimension | Note | |
|---|---|---|---|
| Rear lid to side section | -G- | 4,5 +/-1 mm | Determine gap left to right |
| Rear lid to rear spoiler | -H- | 5+/-1 mm | Rear lid only lowered |
| Rear lid to spoiler top section | -I- | 4,5 +/-1 mm | Rear lid only lowered (max. mm) |
| Rear center panel to spoiler top section | -J- | 6+/-1 mm | Rear lid only lowered (max.1 mm) |
| Rear lid to spoiler top section | -K- | 4,5 +/-1 mm | Rear lid only lowered (max. 1 mm), determine seam |
| Rear center part to rear lid | -R- | 5,2 +/-1 | Only lowered |