Fault code 7: Diagnosis/troubleshooting
DIAGNOSIS/TROUBLESHOOTING (FAULT CODE 7)
| Work instruction | Display OK | If not OK | ||
|---|---|---|---|---|
| 1 | Check central locking switch. |
|
0 V Step 2 |
Repair wiring harness. -> End |
| 2 | Check central locking switch. |
|
Approx. 180 at 20 °C. Step 3 |
Replace resistor or repair wiring harness. -> End |
| 3 | Check operating points of central locking switch. |
|
Central locking switch not actuated to open. Central locking switch actuated to Open. < 5 Step 4 |
Step 5 -> End |
| 4 | Check operating points of central locking switch. |
|
Central locking switch not actuated to "closed". Central locking switch actuated to closed. < 5 Step 6 |
Step 5 -> End |
| 5 |
|
->End | ||
| 6 |
|
-> End | ||