Test point 14

Washer fluid level

• Ignition on
• Engine off

  PST2 display: OK

• Check washer fluid level
• Switch off ignition
• Washer fluid level full
• Pull off plug on sensor for fluid level display
• Ohmmeter directly on sensor for fluid level display, pin 1 and pin 2

  Ohmmeter display: < 5 ohm

  If not, replace sensor for fluid level display.

• Ohmmeter on plug of sensor for fluid level display pin 2 and ground
• Ohmmeter display: < 5 ohm
• Pull off plug II on the instrument cluster
• Ohmmeter on instrument cluster plug II pin 26 and plug on sensor for fluid level display, pin 1

  Ohmmeter display: < 5 ohm

• See also Drive Links, WASHER FLUID WARNING LIGHT  .