Fault code 9110: Diagnosis/troubleshooting

DIAGNOSIS/TROUBLESHOOTING FAULT CODE 9110

Work instruction			Display OK	If not OK
1	Readout DME fault memory	Read out DME fault memory and remedy any stored faults that are not relevant to the CAN	The fault is remedied ->End	Step 2
2	Check CAN-high drive for open circuit	Switch off ignition Remove plug A from the instrument cluster Pull plug Doff the DME control module Measure resistance between plug A on the instrument cluster pin 15 and plug D on DME control module pin 36	< 5 Step 3	Repair wiring harness ->End
3	Check CAN-low drive for open circuit	Measure resistance between plug A on the instrument cluster pin 31 and plug D on DME control module pin 37	a< 5 Step 4	Repair wiring harness ->End
4	Replace the DME control module		->End