Installing roof lining (roof rail flange cover)
NOTE:
- Observe assembly sequence!
- The cover of the rear centre panel should be stuck on first, then the cover of the roof rail flange on the left and right.
ROOF RAIL FLANGE COVER INSTALLING PROCEDURE (TARGA)
| No. | Procedure | Instructions |
|---|---|---|
| Before installing the covers, the flanges of the body must be cleaned. | ||
| 1 | Installing cover of rear centre panel | Pull protective film off the bonding areas. Position the centring notch of the cover -A1-A2- . See Fig 1 . |
| 2 | Installing roof rail flange cover on the left and right | Pull protective film off the bonding areas. -1-2-X-section C-C-
. See Fig 1
. Position cover -1-2-X-section C-C- . See Fig 1 . |
| 3 | Pressing cover in below the cover of the C-pillar | Press cover in below the cover of the C-pillar -C- . See Fig 1 . |