LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lights, Lamps, Switches - 911 CARRERA (996) >> Removing and installing servo motor for automatic headlight beam adjustment >> Removal

Removing and installing servo motor for automatic headlight beam adjustment: Removal

  1. Switch off the light. Release the headlight housing and pull out forwards slightly.
  2. Disconnect the electrical plug connection of the automatic headlight beam adjustment and remove the headlight housing.
  3. Release and open the cover with control module. Disconnect the electrical plug connection from the servo motor and undo the two fastening screws.
  4. Remove the ignition unit (two fastening screws).
    5. Fig 1: Removing Screws And Ignition Unit
    G03063657Courtesy of PORSCHE OF NORTH AMERICA, INC.
  5. Press the release lever down with a screwdriver and pull out the servo motor towards the rear.
    Fig 2: Pressing Release Lever Down & Removing Servo Motor For Automatic Headlight Beam Adjustment
    G03063658Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals