Audio tests
The following functions can be run using this menu item:
- Manual single selection.
- Automatic test.
PCM2 GATEWAY AUDIO TEST FUNCTIONS
| Menu item |
Function |
|
|
This menu item allows you to carry out a manual audio test on vehicles with an internal amplifier.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition.
- Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key.
- Select PCM in the Control modules menu and confirm with the "FORWORD" key.
- Select PCM2 GW in the 911 (996) PCM2 function selection and confirm with the "FORWORD" key.
- Select Audio tests in the PCM2 GW function selection and confirm with the "FORWORD" key.
- Select Manual single selection
in the PCM2 GW audio tests function selection and confirm with the "FORWORD" key.
- Select the required loudspeaker system and confirm with the "FORWORD" key.
The following selection is available:
- Front left, test frequency 1 kHz
- Front right, test frequency 1 kHz
- rear left, test frequency 1 kHz
- rear right, test frequency 1 kHz
- "F5" Boost volume
- "F6" Lower volume
- "F8" Start test
|
|
|
This menu item allows you to carry out a automatic audio test on vehicles with an internal amplifier.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition.
- Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key.
- Select PCM in the Control modules menu and confirm with the "FORWORD" key.
- Select PCM2 GW in the 911 (996) PCM2 function selection and confirm with the "FORWORD" key.
- Select Audio tests in the PCM2 GW function selection and confirm with the "FORWORD" key.
- Select the menu item Automatic test and confirm with the "FORWORD" key.
The test sequence is automatic. |