Input signals
The following queries can be run using this menu item:
NOTE:
Deactivate the automatic traffic announcement before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort.
INPUT SIGNALS - 3DB LOWERING
| Menu item |
Function |
|
|
Under this menu item, it is possible to check the electrical and optical MOST during troubleshooting.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition.
- Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key.
- Select PCM in the Control modules menu and confirm with the "FORWORD" key.
- Select PCM2 GW in the 911 (996) PCM2 function selection and confirm with the "FORWORD" key.
- Select Input signals in the PCM2 GW function selection and confirm with the "FORWORD" key.
- Select 3dB lowering
in the PCM2 GW input signals function selection and confirm with the "FORWORD" key.
- Read out values from the display field.
|