8005 PCM2 - gateway: Diagnosis/troubleshooting
TROUBLESHOOTING (8005 PCM2 - GATEWAY)
| Work instruction |
Display OK |
If not OK |
| 1 |
Read out PCM2 fault memory. |
- Connect the Porsche System Tester II 9588 to the diagnostic socket, start it and switch on the ignition.
- Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key.
- Select PCM in the Control modules menu and confirm with the "FORWORD" key.
- Select PCM2 GW in the PCM2 function selection and confirm with the "FORWORD" key.
- Click the "FORWORD" key in the Fault memory menu.
- Read out fault memory.
- Clear fault memory.
- Remove ignition key and switch on ignition again.
- Read out fault memory.
- Extract ambient data, press the "FORWORD" key.
|
The fault is remedied. -> End. |
Step 2. |
| 2 |
Check CAN comfort (high) for open circuit. |
- Switch off the ignition.
- Pull off plug C on the PCM2.
- Pull off plug A on the instrument cluster control module.
- Pull off plug B on the air-conditioning system control module.
- Measure specific resistance between pin 1 of plug C on the PCM2 control module and pin 14 of plug A on the instrument cluster control module.
|
< 0.5. Step 3. |
Repair open circuit in wiring harness. -> End. |
| 3 |
Check CAN comfort (low) for open circuit. |
- Measure specific resistance between pin 2 of plug C on the PCM2 control module and pin 15 of plug A on the instrument cluster control module.
|
< 0.5. Step 4. |
Repair open circuit in wiring harness. -> End. |
| 4 |
|
-> End. |