| 1 |
Read out fault memory. |
- Connect and start the Porsche System Tester II 9588 and switch on the ignition.
- Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key.
- Select PCM in the Control units menu and confirm with the "FORWORD" key.
- Select PCM2 GW in the PCM2 function selection and confirm with the "FORWORD" key.
- Start Fault memory in the menu using the "FORWORD" key.
- Read out fault memory.
- Erase fault memory.
- Remove ignition key and switch on ignition again.
- Read out fault memory.
- Extract ambient data, press the "FORWORD" key.
|
The fault is remedied
-> End |
Fault code is still displayed
Step 2 |