Fault code 13: Diagnosis/troubleshooting
DIAGNOSIS/TROUBLESHOOTING (FAULT CODE 13)
| Work instruction |
Display OK |
If not OK |
| 1 |
Check wire from control module to the left door lock for short circuit to ground. |
- Switch off the ignition.
- Pull plug A off the alarm system control module.
- Pull plug off the left door lock.
- Left-hand drive vehicle: Measure resistance between plug A on control module pin 30 and ground.
- Right-hand drive vehicle: Measure resistance between plug A on control module pin 32 and ground.
|
Step 2 |
Repair wiring harness.
-> End |
| 2 |
Check wire from control module to the left door lock for short to B+. |
- Switch on ignition.
- Left-hand drive vehicle: Measure voltage between plug A on control module pin 32 and ground.
- Right-hand drive vehicle: Measure voltage between plug A on control module pin 30 and ground.
|
0 V
Step 3 |
Repair wiring harness.
-> End |
| 3 |
Check wire from control module to left door lock for open circuit. |
- Switch off the ignition.
- Left-hand drive vehicle: Measure resistance between plug A on control module pin 30 and pin 3 of plug on left door lock.
- Right-hand drive vehicle: Measure resistance between plug A on control module pin 32 and pin 3 of plug on left door lock.
|
< 5
Step 4 |
Repair wiring harness.
-> End |
| 4 |
|
-> End |