Test point 2: Troubleshooting:

• Switch off ignition
• Pull off plug II on the instrument cluster
• Switch ignition on
• Lift the vehicle
• Rotate the rear left wheel by hand
• Measure the voltage between plug II pin 16 and ground (AC range)
• Voltmeter display > 1 V

If the wheel speed signal is present at the instrument cluster, replace the instrument cluster. If the wheel speed signal is not present at the instrument cluster:

• Switch off ignition
• Pull plug off the ABS control module
• Ohmmeter on instrument cluster plug II pin 16 and ground Ohmmeter Display: "INFIN" Ω
• Ohmmeter on instrument cluster plug II pin 16 and plug on ABS control module pin 21

  Ohmmeter display: < 5 Ω