Possible causes, elimination, Notes
NOTE:
This fault can also be caused by incorrect operation (door lock actuated toward "closed" direction for longer than 60 seconds).
- Pull off plug I on the alarm control module.
- Disconnect plug connection X 11 (driver's side).
- Disconnect the plug connection X 12 (passenger's side).
- Check the leads from the alarm control module plug I pin 35 to the door lock modules for short to ground.
- Ohmmeter at alarm control module plug I pin 35 and ground Display: "INFIN" Ω
- Check driver's side door lock module switch contact.
- Ohmmeter at plug connection X 11 pin A4 (sleeve side) and ground.
Door lock not actuated.
Display: "INFIN" Ω
Door lock actuated towards "Closed".
Display: < 5 Ω
- Ohmmeter at plug connection X 11 pin A4 (sleeve side) and ground.
- Check passenger's side door lock module switch contact.
- Ohmmeter at plug connection X 12 pin A4 (sleeve side) and ground.
Door lock not actuated.
Display: "INFIN" Ω
Door lock actuated towards "Closed".
Display: < 5 Ω
- Ohmmeter at plug connection X 12 pin A4 (sleeve side) and ground.