Pot. 1, convertible top
WARNING: This page is about a different variant/trim than selected.
The values between pot. 1, calibration value 1, and pot. 1, calibration value 6, are calculated as percentage by the convertible-top control module.
If the actual values (measured values) of calibration values 1 and 6 differ, the convertible-top potentiometer must be replaced. Refer to REMOVING AND INSTALLING POTENTIOMETER FOR CONVERTIBLE-TOP INTERROGATION .
- Pot. 1 calibration value 1 Tester display must be less than < 1.6 volts
- Pot. 1 calibration value 2
- Pot. 1 calibration value 3
- Pot. 1 calibration value 4
- Pot. 1 calibration value 5
- Pot. 1 calibration value 6 Tester display must be greater than > 3.0 volts