Installing bulb for auxiliary headlight

WARNING: This page is about a different variant/trim than selected.

NOTE: See INSTALLING BULBS .

Fig 1: Engaging Electrical Plug Connection & Installing Bulb Holder Into Headlight Housing

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Guide the bulb holder into the headlight housing and turn clockwise on the left headlight and counter-clockwise on the right headlight. Ensure correct seating.
Put the cap -1- into position and press down until both locking tabs -B- engage. Screw in both fastening screws -A- . Tightening torque: 4 Nm (3 ftlb.).

Fig 2: Installing Cap, Engaging Locking Tabs & Screwing In Fastening Screws
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Install main headlight and perform a function test.