Installing bypass flap control box on the turbocharger

Push the push rod of the control box into the bypass flap release.
Secure the control box by screwing in and tightening the two holder screws.

Fig 1: Securing Control Box
Courtesy of PORSCHE OF NORTH AMERICA, INC.

Tightening torque 10 Nm (7.5 ftlb.)
Screw the nut on the push rod.

Fig 2: Locating Nut On Push Rod
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Adjust the control box. Refer to CHECKING AND ADJUSTING THE BYPASS FLAP CONTROL BOXES ON THE TURBOCHARGER .
Push the vacuum hose on to the control box.

Fig 3: Pushing Vacuum Hose On To Control Box
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Fit the safety bracket again, and check for correct seating.

Fig 4: Installing Safety Bracket
Courtesy of PORSCHE OF NORTH AMERICA, INC.