Undoing and tightening the belt pulley
NOTE:
The belt pulley can be undone or tightened using a standard commercially available tool.
- Double offset ring wrench a/f 24
- Screwdriver insert for internal serration screw a/f 10
- Cross handle and torque wrench
- The hexagon nut a/f 24 must be countered with the ring wrench during tightening.
- The shaft is tightened to the prescribed tightening torque of 65 +/- 5 Nm (48 +/- 3.5 ftlb.) using the screwdriver insert and the torque wrench.