LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2002 >> 911 Turbo, Automatic >> Repair and Diagnosis >> Electrical >> Body Electrical >> Starter, Power Supply - 911 Turbo (996) >> Removing and installing starter (automatic transmission) >> Installing the starter

Installing the starter

  1. Install and fasten starter. Fasten B+ lead from the battery and B+ lead from the engine B+ disconnection point to terminal 30 (M8 nut) on the solenoid switch.
  2. Fasten terminal 50 lead (M6 nut) to the solenoid switch.

    Tightening torque for M8 hexagon nut: 15 Nm (11 ftlb.), M6 screw: 6.5 Nm (5 ftlb.) 

    Tightening torque of the hexagon-head bolt M10: 46 Nm (34 ftlb.) 

  3. Push protective cap over the solenoid switch and engage in the B+ lead.
  4. Fasten the sheetmetal holder on the transmission flange lid and engage the plastic holder.
  5. Fasten the coolant lines under the automatic transmission and install the cross member.
  6. Install the parking brake cable and fasten the cover under the automatic transmission.
  7. Connect the battery and perform a function test.
scientia non olet · About LEMON Manuals