Battery - handling notes: Notes
NOTE:
- Battery terminals should not be greased.
- The battery terminal clamps should only be attached without force to prevent damage to the battery housing.
- The tightening torque for the battery clamps is 5 Nm (4 ftlb.).
- If the battery is to be reconnected, proceed according to WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
- To guarantee that the battery does not leak, it is necessary that the original plug accompanying the battery is screwed into the battery openings.
- In the case of loss or damage, only original plugs of the same design should be used.
- The plugs must be fitted with an o-ring seal.