Installing covering for the front backrest frame
PROCEDURE FOR INSTALLING COVERING FOR FRONT BACKREST FRAME - AS OF MY 1997 TO 2002 (1 OF 3)
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Positioning foam part | Position foam part on the backrest frame. |
| 2 | Installing backrest covering | Fit the backrest covering onto the backrest frame. Press the covering bead -7-8- |
| 3 | Fitting the backrest covering at rear | Press the connection of the backrest covering into the backrest shell at the rear-9- |
| 4 | Folding over the side bolsters | Screw in the connection -11-direction of arrow- |
PROCEDURE FOR INSTALLING COVERING FOR FRONT BACKREST FRAME - AS OF MY 1997 TO 2002 (2 OF 3)
| No. | Procedure | Instructions |
|---|---|---|
| 5a | Closing side bolster closure, new status | Engage the side bolster closure -10- |
| 5b | Closing side bolster closure, old status | Join both side bolster closures -10- |
| 6 | Installing clothes hook | Position the clothes hook -6-5- |
| 7 | Installing release lever | Inset the collar -4-3 - |
| 8 | Installing backrest cover Installing the backrest centre strip |
Insert the side backrest cover -2-1- See INSTALLING THE BACKREST CENTRE STRIP |
CAUTION:
- Danger of material damage if excessive heat is applied!
- If creases form, only short partial warming with the hot-air gun is permissible. The hot-air temperature of approx. 50 degrees Celsius (122 Fahrenheit) must always be observed.
PROCEDURE FOR INSTALLING COVERING FOR FRONT BACKREST FRAME - AS OF MY 1997 TO 2002 (3 OF 3)
| No. | Procedure | Instructions |
|---|---|---|
| Remedying creases in the backrest cover | If creases form in the areas of the backrest cover, heat them partially with the hot-air gun. |