LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2002 >> 911 Turbo, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Window Motors & Regulators >> Glasses, Window Control - 911 Turbo (996) >> Removing and installing side window >> Installing side window

Installing side window

NOTE:
  • The removed side window can be reinstalled if:
  • there is no prior damage to the side window.
  • the side window was removed without being damage
Fig 1: Installing Side Window
G03094498Courtesy of PORSCHE OF NORTH AMERICA, INC.
INSTALLING SIDE WINDOW

No. Procedure Instructions
1 Fitting the rubber seal Fit the rubber seal-5- 
2 Remove side window. Affix suction cups to the side window. Insert side window -4-direction of arrow- 
  • 1 Keep pressing the side window -4-  upwards in -direction of arrow B-  and insert at the bottom.
  • 2 Pull the lip of the seal forward under the side window -4-  using a plastic spatula.
  • 3 Keep pressing the side window -4-  upwards in -direction of arrow B-  and insert the spacer in the retaining rail.
3 Adjusting gap dimension See TEST AND ADJUSTING VALUES 
4 Unscrew fastening nuts and screws. Screw down the fastening screw -1-2-3- 
Install B and C pillars Refer to REMOVING AND INSTALLING TRIM OF A, B AND C-PILLARS .
scientia non olet · About LEMON Manuals