LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2002 >> 911 GT2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Exterior Lights, Lamps, Switches - 911 CARRERA (996)) >> Removing and installing control module for gas discharge lamp as from model year '02 >> Removing control module for gas discharge lamp

Removing control module for gas discharge lamp

WARNING: This page is about a different variant/trim than selected.
  1. Switch off light.
  2. Remove main headlight. See REMOVING MAIN HEADLIGHT  .
  3. Unscrew fastening screws -arrow-  from the control module holder and remove holder.
    4. Fig 1: Removing Control Module Holder & Screws (From MY '02)
    G03063650Courtesy of PORSCHE OF NORTH AMERICA, INC.
  4. Raise the catch of the electrical plug connection (grey plug) with a screwdriver and disconnect.
  5. Unscrew both fastening screws -A-  , press both locking tabs -B-  and remove the rear cap -1-  .
    Fig 2: Unscrewing Fastening Screws, Pressing Locking Tabs & Removing Rear Cap (From MY '02)
    G03063651Courtesy of PORSCHE OF NORTH AMERICA, INC.
  6. Unscrew electrical plug connection -B-  on the gas discharge lamp (bayonet lock).
    Fig 3: Unscrewing Electrical Plug Connection On Gas Discharge Lamp (From MY '02)
    G03063652Courtesy of PORSCHE OF NORTH AMERICA, INC.
  7. Unclip the wiring arrangement -A-  from the closure cap and remove the control module with the closure cap wire. See Fig 3 .
scientia non olet · About LEMON Manuals