LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2002 >> 911 GT2 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical - 911 Turbo (996) >> Removing and installing the rear disc brake pads - GT2 / Turbo with PCCB >> Notes

Removing and installing the rear disc brake pads - GT2 / Turbo with PCCB: Notes

WARNING: Danger of accident if brake pads with the wrong brake pad quality are installed! Use only the type-specific brake pads in the Porsche Spare Parts Catalogue!
NOTE:
  • The GT2 is equipped with PCCB (Porsche Ceramic Composite Brake) as standard!
  • In contrast to this, at the start of production, steel brake discs and brake pads are used at first!
  • The pad backing plates (rear side of the brake pads) must not be greased!
  • 2 vibration dampers -arrows- are fitted on each of the brake pad supports!
    Fig 1: Identifying Vibration Dampers On Brake Pad Supports
    G03093918Courtesy of PORSCHE OF NORTH AMERICA, INC.
  • Vibration dampers are provided as additional damping measures!
    Fig 2: Identifying Damper Plates
    G03093919Courtesy of PORSCHE OF NORTH AMERICA, INC.
  • Replace vibration dampers each time the pads are changed!
  • The damper plates have an adhesive protective film! The protective film must be pulled off before installation!
scientia non olet · About LEMON Manuals