Function of individual components
- Control module
Processes the incoming signals and, if necessary, triggers an alarm.
- Alarm readiness light
Function 1
Display of the locking state.
Function 2
Display of the operating state of the alarm system.
Six display types are possible:
- Normal flashing (0.5 Hz)
- Double flashing (0.5 Hz)
- Rapid flashing (2.0 Hz)
- Rapid flashing (10.0 Hz)
- On
- Off
- Central locking button
The doors can be locked and unlocked with the central locking button.
- Door lock module
The door lock modules (driver's/passenger's door) each contain 5 micro switches:
- 1 switch for priming the system (ground pulse).
- 1 switch for deactivating the system (ground pulse).
- 1 switch for recognising door closed.
- 1 switch for recognising door locked.
- 1 switch for recognising door secured.
- Switch, luggage compartment lid, rear
The switch connects ground to the control module.
- Switch, luggage compartment lid, front
The switch connects ground to the control module.
- Switch, oddments tray
The switch connects ground to the control module when the oddments tray is opened.
- Passenger compartment monitoring sensor
The passenger compartment monitoring sensor connects ground to the control module when movement is detected in the vehicle.
- Radio alarm contact
The alarm contact on the radio mounting frame connects ground to the control module when the radio is removed from the frame.
- Switch, convertible top compartment cover
The switch connects ground to the control module.
- Switch, convertible top closed
The switch connects ground to the control module.
- Alarm horn
In the event of an alarm, the horn is supplied with positive potential by the control module.
NOTE: If the positive supply for the alarm horn is interrupted, the visual alarm is triggered via the direction indicator lights and the interior lights. - Signal converter
The signal converter obtains the transponder code from the signals sent by the transponder, and then sends this code on to the alarm control module.
- Transponder coil
The transponder coil reads the transponder code out of the transponder.