LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2001 >> Boxster Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System, Electronic Injection >> Removing and installing oxygen sensors behind catalytic converter - as of MY 2003 >> Installing oxygen sensors behind catalytic converter - RoW

Installing oxygen sensors behind catalytic converter - RoW

  1. Position the oxygen sensor by hand and screw in as far as possible.
  2. Tighten oxygen sensor with conventional open ring wrench Hazet 4681-3 and torque wrench.

    Tightening torque 55 (41) +/- 5 (3.5) Nm (ftlb.) 

  3. Connect the oxygen sensor connecting plugs and secure by inserting the plug lock.
  4. Fit rubber sleeve between oxygen sensor cable and heat insulation plate.
  5. Install rear wheel housing liner on the corresponding side.
scientia non olet · About LEMON Manuals