Removing oil container for exhaust turbocharger

WARNING:

Danger of scalding from draining oil!
Danger of burns! Parts of the exhaust system can be extremely hot.
Do not begin work until the exhaust system has cooled down or wear suitable protective gloves!

WARNING: Danger of fire! The heat shield should not be bent or deformed. Bent or deformed heat shields must be replaced.

Requirement:

Remove heat shield. Refer to REMOVING AND INSTALLING REAR BUMPER .

Fig 1: Installing Heat Shield
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Unscrew the oil drain plug -arrow- of the oil container and collect any emerging oil.

Fig 2: Installing Oil Drain Plug Of Oil Container
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Unscrew the M6 screw on the heat shield -arrow-.

Fig 3: Removing Screw On Heat Shield
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Undo both union nuts of the oil lines -arrows- a/f 17 and pull the lines out of the oil container by removing the M6 screw -arrow- from the oil line holder.

Fig 4: Removing Union Nuts Of Oil Lines On Oil Container
Courtesy of PORSCHE OF NORTH AMERICA, INC.

Fig 5: Locating Oil Line Holder
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Unscrew both fastening screws (hexagon socket a/f 6) -arrows-.

Fig 6: Removing Fastening Screws (Hexagon Socket A/F 6)
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Remove oil container.
NOTE: Always replace the oil sealing ring -arrow- and the sealing ring for the oil drain plug!

Fig 7: Identifying Oil Sealing Ring
Courtesy of PORSCHE OF NORTH AMERICA, INC.