- Lightly grease the adjustment device No. -2-
, pins No. -8-
/No. -9-
on the actuating lever (spreading lever) and the sliding surfaces of the parking brake shoes.
- Install the actuating lever (spreading lever) No. -12-
, brake shoes, return springs, compression springs and adjustment device. Refer to Fig 1. The spreading lever (No 12.) is a 1-part assembly that cannot be disassembled. This assembly consists of parts No. -6-
, No. -7-
and No. -8-.
Courtesy of PORSCHE OF NORTH AMERICA, INC.
NOTE:
The hook (the curved end of the spring) of compression spring No. -10- must point upward on the upper brake shoe and downward on the lower brake shoe.
- Again check to ensure that the parking brake shoes, adjustment device, return springs, compression springs and spreading lever are positioned correctly, and adjust if necessary.
NOTE:
Ensure that the hooks of the compression springs No. 10 correctly clasp the wheel carrier A (if necessary, check with the aid of a mirror).
Courtesy of PORSCHE OF NORTH AMERICA, INC.
- Clean the levelling and centering surfaces on the brake disc and wheel hub. Then apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
- Fit the brake disc.
NOTE:
- Do not confuse right and left brake discs during assembly.
- Distinguishing characteristic: involute shape and spare part number (SP No.). The flat surface of the brake discs is marked with R = right or L = left.
- Spare part on left-hand side - third group number is odd (SP No. Left brake disc: 996.352.405.00).
- Spare part on right-hand side - third group number is even (SP No. Right brake disc: 996.352.406.00).
Courtesy of PORSCHE OF NORTH AMERICA, INC.
- Adjust the parking brake shoes and parking brake cables. Fit the brake caliper. Tightening torque of the fastening screws: 85 Nm (63 ftlb.). Ensure that the brake hose and brake line are in perfect position.
NOTE:
Replace the brake caliper fastening screws after each removal.