LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2001 >> 911 Turbo, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical - 911 Turbo (996) >> Installing air ducts for PCCB brake discs - GT2 >> Installing rear air ducts

Installing rear air ducts

  1. Push air duct (brake-air spoiler) onto the lower rear axle control arm from the front.
    Fig 1: Pushing Air Duct (Brake-Air Spoiler) Onto Lower Rear Axle Control Arm From Front
    G03093974Courtesy of PORSCHE OF NORTH AMERICA, INC.
    • Subsequently fit the retaining clip -2-  (included in the scope of delivery) from the rear. The retaining clip -2-  must be inserted into the slot of the air duct -arrow-  at the top. Refer to Fig 2.
      Fig 2: Identifying Air Duct, Retaining Clip & Expansion Rivets
      G03093975Courtesy of PORSCHE OF NORTH AMERICA, INC.
    • Connect the retaining clip -2-  to the air duct -1-.  For this purpose, push the three expansion rivets -3-  (included in the scope of delivery) into the bores drilled in the bracket and the air duct (two from above and one from behind).
    NOTE:
    • Fig 2 shows the rear of the air duct -1- (removed)!
    • The left and right air duct -1- and retaining clip -2- differ from each other!
  2. Mount the air duct in the same manner on the other side of the vehicle.