Fitting six-point seat belt - GT2

Loop technique for fastening the seat belt to the bucket seat cross member
Loop the belt strap in the direction of the arrow -inset- around the bucket seat transverse strut into the adjustable slider. The projection -dimension = X- of the belt strap must be at least 100 mm.

Fig 1: Looping Belt Strap - GT2, As Of MY 2001
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Pulling six-point seat belt through the openings in the bucket seat
Pull six-point seat belt through the upper openings in the backrest from behind -arrow A- and through the openings in the seat frame from the side -arrow B- .

Fig 2: Pulling Six-Point Seat Belt Through Upper Openings In Backrest From Behind - GT2, As Of MY 2001
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Fitting belt fitting

Fig 3: Fitting Belt Fitting - GT2, As Of MY 2001
Courtesy of PORSCHE OF NORTH AMERICA, INC.

Position foam part -4- and belt fitting -5- at the left and right on the seat frame. Refer to Fig 3 . With the shim -3- and the fastening screw -2- , screw the belt fitting -5- tight. Position the cover -1- on the fastening screw -2- .

Use the foam part -4- for the Club Sport version.

For the Cup racing version, mount the bushing -6- instead of the foam part.

Tightening torque: 50 Nm (37 ftlb.)
Loop technique for fastening the seat belt to the bucket seat cross member
1. Loop the belt strap in the direction of the arrow -inset- around the transverse strut on the roll cage into the adjustable slider. The projection -dimension = X- of the belt strap must be at least 100 mm.
2. Roll up the projecting belt strap and bind it with a tie wrap -1- .
Fig 4: Rolling Up Projecting Belt Strap And Binding It With Tie Wrap - GT2, As Of MY 2001
Courtesy of PORSCHE OF NORTH AMERICA, INC.