LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2000 >> Boxster Base, Standard >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System, Electronic Injection >> Removing and installing oxygen sensors in front of catalytic converter - as of MY 2003 >> Installing oxygen sensors in front of catalytic converter - USA

Installing oxygen sensors in front of catalytic converter - USA

  1. Position the oxygen sensor by hand and screw in as far as possible.
  2. Tighten oxygen sensor with conventional open ring wrench Hazet 4681-3 and torque wrench.

    Tightening torque 55 (41) +/- 5 (3.5) Nm (ftlb.) 

  3. Route the blue oxygen sensor cable and secure it in the sheet metal brackets, wire retainers, or the cable guide.
  4. Connect plug connection and insert in the holder.
scientia non olet · About LEMON Manuals