800A CDR23: Diagnosis/troubleshooting
DIAGNOSIS/TROUBLESHOOTING - 800A CDR23
| Work instruction |
Display OK |
If not OK |
| 1 |
Read out CDR23 fault memory |
- Connect the Porsche System Tester II 9588 to the diagnostic socket; switch on the ignition and the Porsche System Tester II 9588
- Select 986 as the vehicle type and start the automatic control module search
- In the Control units menu, select CDR23
- Click the "> >" key in the Fault memory menu
- Read out fault memory
- Erase fault memory
- Remove ignition key and switch on ignition again
- Read out fault memory
|
-> End |
Fault code is still displayed
Step 2 |
| 2 |
Check CAN comfort (high) for open circuit |
- Switch off ignition
- Pull off plug E on CDR23 control module
- Pull off plug B on the air-conditioning system control module
- Pull off plug A on the instrument cluster control module
- Measure specific resistance between pin 1 of plug E on the PCM2 control module and pin 1 of plug B on the air-conditioning control module
|
< 0.5
Step 3 |
Repair open circuit in wiring harness
-> End |
| 3 |
Check CAN comfort (low) for open circuit |
- Measure specific resistance between pin 2 of plug E on the PCM2 control module and pin 2 of plug B on the air-conditioning control module
|
< 5
Step 4 |
Repair open circuit in wiring harness
-> End |
| 4 |
|
-> End |