Diagnosis/troubleshooting on the PCM2 navigation module
DIAGNOSIS/TROUBLESHOOTING ON THE PCM2 NAVIGATION MODULE - 8002 NAVIGATION
| Work instruction Display OK |
Display OK |
If not OK |
| 1 |
Read out PCM2 fault memory |
- Connect the Porsche System Tester II 9588 to the diagnostic socket; switch on the ignition and the Porsche System Tester II 9588
- Select 986 as the vehicle type and start the automatic control module search
- In the Control units menu, select PCM2
- Click the "> >" key in the Fault memory menu
- Read out fault memory
- Erase fault memory
- Remove ignition key and switch on ignition again
- Read out fault memory
|
-> End |
Fault code is displayed |
| 2 |
Replace PCM2 navigation module |
-> End |