Fault code 5: Elimination:

• Switch off ignition
• Pull plug off the angle sensor for HBA, front 
• Switch ignition on
• Read the fault memory and observe whether fault code 5 reappears.

If fault code 5 does not reappear, the supply lead to the angle sensor for HBA, front,  is faulty. Proceed as follows in this case:

• Measure voltage between terminal 5 of the sensor plug and ground Voltmeter display approx. 5 V
• Measure voltage between terminal 5 and terminal 1 of the sensor plug
• Voltmeter display approx. 5V
• In the PST2 menu item Actual values,  select Sensor voltage, spring travel 1
• Connect a jumper to terminals 4 and 5 of the sensor plug

  PST2 display approx. 5 V

If no fault is detected in the wires or control module, replace the angle sensor for HBA, front. 

If fault code 5 reappears after the plug has been removed from the angle sensor for HBA, front,  there is a fault in the supply lead to the angle sensor for HBA, rear.  Proceed as follows in this case:

• Pull plug off the angle sensor for HBA, rear 
• Measure voltage between terminal 5 of the sensor plug and ground Voltmeter display approx. 5 V
• Measure voltage between terminal 5 and terminal 1 of the sensor plug

  Voltmeter display approx. 5 V

• In the PST2 menu item Actual values,  select Sensor voltage, spring travel 2
• Connect a jumper to terminals 4 and 5 of the sensor plug

  PST2 display approx. 5 V

If no fault is detected in the wires or control module, replace the angle sensor for HBA, rear.