LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2000 >> Boxster Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> DME 7.2 - 911 CARRERA & BOXSTER >> DTC P1325: Camshaft Adjustment, Bank 2 - Signal Implausible >> Diagnosis Procedure >> Check Triggering Wire For Continuity

Check Triggering Wire For Continuity

  1. Connect special tool 9637 to wiring harness (DME control module connector).
  2. Remove connector of actuator.
  3. Connect ohmmeter to special tool 9637, pin V/3 and connector, pin 2.

    Display: 0-5 ohms

    NOTE: The wire is routed via connector X 59/1.
scientia non olet · About LEMON Manuals