LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2000 >> Boxster Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> DME 7.2 - 911 CARRERA & BOXSTER >> DTC P0343: Camshaft Position Sensor 1 - Above Limit >> Diagnosis Procedure >> Check signal wire from DME control module, pin III/20, to CMP sensor

Check signal wire from DME control module, pin III/20, to CMP sensor

  1. Connect special tool 9637 to wiring harness (DME control module connector).
  2. Remove connector of CMP sensor.
  3. Connect ohmmeter to special tool 9637, pin III/20, and to CMP sensor connector 1, pin 2.

    Display: 0 - 5 ohms

scientia non olet · About LEMON Manuals