LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2000 >> Boxster Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> DME 7.2 - 911 CARRERA & BOXSTER >> DTC P0343: Camshaft Position Sensor 1 - Above Limit >> Diagnosis Procedure >> Check power supply wiring for continuity

Check power supply wiring for continuity

  1. Remove connector of CMP sensor 1.
  2. Connect special tool 9637 to wiring harness (DME control module connector).
  3. Connect ohmmeter to special tool 9637, pin III/7, and to CMP sensor connector 1, pin 3.

    Display: 0 - 5 ohms

  4. Connect ohmmeter to special tool 9637, pin III/17, and to CMP sensor connector 1, pin 1.

    Display: 0 - 5 ohms

scientia non olet · About LEMON Manuals