Input signals
The following queries can be run using this menu item:
NOTE:
Deactivate the automatic traffic announcement before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort (applies only to software < 03).
INPUT SIGNALS ITEM - FUNCTION (NAVIGATION)
| Menu item |
Function |
|
|
The reverse-gear signal can be read out using this menu item.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition.
- Select Boxster (986) in the Vehicle type menu and confirm with the ">>" key.
- Select PCM in the Control units menu and confirm with the ">>" key.
- Select Navigation in the Boxster (986) PCM2 function selection and confirm with the ">>" key.
- Select Input signals in the Boxster (986) navigation function selection and confirm with the ">>" key.
- Select Reverse-gear signal in the Boxster (986) Navigation input signals function selection and confirm with the ">>" key.
- Read out values from the display field.
|