LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1988 >> 924 Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> CROSSMEMBER Tube >> Installation

CROSSMEMBER Tube: Installation

  1. Apply rubber lubricant to lower mount bushings. Install crossmember tube with lower retaining bolts. Remove upper mounts from body and install on torque struts, but DO NOT tighten bolts.
  2. Install control arms with pivot bolts. Disconnect shock absorber from control arm. Install control arm to spring plate, But DO NOT tighten bolts. Reinstall shock absorber to control arm.
  3. Install upper retaining bolts to body approximately 2-3 threads deep. Tighten torque strut-to-mount bolts. Tighten all remaining mount bolts.
  4. Lower transaxle and remove support chain. Install and tighten transaxle retaining nuts. Reinstall parking brake cables and retainers. Install wheel assemblies and lower vehicle.
  5. Check and adjust rear axle alignment. After alignment, raise vehicle and remove rear wheel assemblies. Tighten all nuts and bolts to specification. Install stabilizer bar links.
scientia non olet · About LEMON Manuals