LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1986 >> 928 Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Rear Disc Brake Pads >> Removal

Rear Disc Brake Pads: Removal

  1. Pull sensor for brake pad wear indicator out of pad plate. Replace sensors with ground through or grinding on core of wires. Sensor can be re-used, if there are grinding traces only on plastic part of sensor.
  2. Remove locks with wire guide plate and retaining pins. Remove inner brake pad with pulling hook or impact puller.
  3. Remove outer brake pad. This requires pressing out floating caliper frame until brake pad protrudes out of pin on floating frame caliper.
scientia non olet · About LEMON Manuals