LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1986 >> 928 Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Brake Rotor >> Removal

Brake Rotor: Removal

  1. Raise and support vehicle. Remove tire and wheel. Remove caliper as previously described and hang from frame with wire. Do not disconnect hydraulic line.
  2. On front brake rotors, remove dust cap, loosen clamp lock screw, then remove clamp nut and thrust washer. Remove rotor and wheel bearings as an assembly, then separate.
  3. On rear brake rotors, remove rotor attaching bolts and remove rotor. Mark rotor and hub for reassembly reference. Remove hub-to-rotor bolts (if equipped) and separate hub from rotor.
NOTE: If rear rotor cannot be removed by hand, insert two 8 mm bolts into attaching screw holes and alternately tighten bolts to press rotor from hub.
scientia non olet · About LEMON Manuals