Installation (Front & Rear Axles)

When installing, note the following:

*  Rubber mounts and grommets on speed sensors are connected with wire covers in precise position.

*  Ensure no foreign metal particles (burrs) are on magnetic edge of speed sensor before installing.

1. Coat speed sensor and bore in steering knuckle with Molykote Longterm 2. Replace speed sensor "O" ring. Insert speed sensor in steering knuckle without force and mount with socket head screw.
2. Clip wire in holders on wheel carrier and rear axle crossmember. Connect wire plug and insert in holder. Mount wheel. Check operation with ABS tester.