LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1985 >> 944 Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - A/T - AUDI 087, 087E, 089 >> Component Disassembly & Reassembly >> Oil Pump Assembly >> Reassembly

Oil Pump Assembly: Reassembly

  1. Install thrust washer on pump housing. Care fully install large piston rings and then small piston rings. Ensure ring ends are hooked together correctly. Lubricate all parts with ATF.
  2. Install inner and outer gears into housing. Side of outer gear with marking (code letter) must face cover plate. Install drive plate with extended hub inserted into pump body away from cover plate. Install check ball and spring. Align cover with housing. Install and tighten attaching screws. See Figure .
NOTE: After reassembly, insert pump shaft into oil pump and ensure that gears rotate smoothly without binding. Gear movement should also be checked after pump is installed in transmission case.
scientia non olet · About LEMON Manuals