LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1985 >> 944 Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - A/T - AUDI 087, 087E, 089 >> Component Disassembly & Reassembly >> Band Servo >> Reassembly

Band Servo: Reassembly

  1. Position spring seat, accumulator spring and shim on piston pin. Install assembly into servo piston and install retaining "E" clip onto pin.
  2. Install lip seals onto piston with smaller (upper) seal with lip facing upward into servo cover. Larger seal is positioned with lip facing downward, out of servo cover.
  3. Lubricate assembly thoroughly and install piston into cover. Install "O" rings on outer diameter of servo cover. See Figure .
Fig 1: Exploded View of E-Mode Valve Body
G00153644Courtesy of AUDI OF AMERICA, INC.

All other models are similar.

Fig 2: Exploded View of Governor Assembly
G00153645Courtesy of AUDI OF AMERICA, INC.

Note transfer plate position for reassembly.

scientia non olet · About LEMON Manuals